Puffco Peak Short Circuit Fixe

Step 5: Unscrew 3 Security Screws. My puffco wont heat up, instead it blinks 5 times, on whichever heat setting i have it on. We're starting off with a standard Puffco Peak base – glass removed. If you have done this before it makes sense, otherwise: read on. I suspect that there is an onboard boost converter that steps USB voltage up to above 7v, and it is defective. The silicone will lift out from under the shiny metal base of the Puffco. Ideally, finding out which component has failed; and swapping it for a working one is best – but my electronics skills are limited.

1. Puffco peak short circuit fix spray
2. Puffco peak short circuit fix plus
3. Puffco peak short circuit fix

Puffco Peak Short Circuit Fix Spray

Do not force this out. The Puffco lights up, and indicates it's taking a charge when plugged in to USB. The teardown video is up on Youtube now: Step by Step Instructions: How to Open a Puffco Peak. Note: In my video, I perform step 5 before step 4 – and it really doesn't matter in the end, but I feel it's easier in this order. The first piece to be removed is a silicone and ceramic ring. In my case – I did some poking around with a multimeter and determined that my battery was not putting out a high enough voltage.

Puffco Peak Short Circuit Fix Plus

I took it apart and cleaned the whole thing pretty well, i thought that would at least solve the connection issue, but it didnt seem to fix it): any tips or any help will be appreciated! 5v to the battery connection leads – the battery charges and holds its charge. It may help to warm this area with a hair dryer or gently using a heat gun. I was told, "It doesn't charge – it's broken. Using your thumbs, press outwards from the center on the base of the Puffco Peak. It's only on USB power that the device fails to charge. Remove all three screws, and your Puffco will almost fall apart in your hands. Step 6: Open and Inspect.

Puffco Peak Short Circuit Fix

The bucket rests directly atop the heating element – extract can glue it in place – and tugging on the element can damage it's fragile connecting wires. Once the silicone boot is loose the the bottom, pry upwards from below the USB port and remove the silicone sort of like a sock, where the atomizer connection is the toe. One of these screws is below a security sticker, revealing silver 'VOID' markings when removed. Place your fingers above the USB port where the shiny material and silicone meet and pry upwards on the shiny metal/plastic piece that surrounds the Puffco Peak. Unscrew the metal housing for the heater by turning it counter clockwise several times to disengage the threads. Use your fingers or a pry tool to peel the metal disc off of the bottom of the plastic Puffco Peak base. It will lift off, and may require a twisting motion or a small amount of heat if it feels stuck. If anyone has input, questions or ideas – I would love to hear them in the comments below or on the Youtube video linked above. 5v – too low to charge a 7. I just needed to get inside and start probing around with my multimeter. What's Wrong with My Puffco Peak? If that isn't the case, I'll be adding an external battery pack to make up for the lack of internal charge circuit.

Be careful and go slow. Begin the disassembly process by removing the atomizer, bucket, and surrounding components. If it feels stuck, apply a small amount of heat and try again. Step 1: Remove the Atomizer & Surrounding Components. Use a screwdriver set like this one from Amazon to remove the three screws holding the plastic assembly together. Step 4: Pry the Metal Base Off. That's it, your Puffco Peak is open before you. These devices are simple, and with that in mind; there shouldn't be too many ways for the device to fail.

Sun, 16 Jun 2024 20:34:18 +0000