Toyota Sienna Sliding Door Won'to Open In A New

In this case, it is best that you replace the latch unit. After lubricating the assembly, try opening and closing the sliding door several times. If I get down close to the bottom of the door near track, I hear a slight metal to metal grinding sound. Weak battery could be the cause. But if you pull the handle and hold it for a few seconds the door opens. My method is pretty generic, it may apply to other car models. Close the sliding door of your Hiace van. Toyota Sienna auto sliding door cable replacement. I used a rotary tool (1st picture) to cut open the latch where the motor was (2nd picture, red circle where the motor is). Went to other side, it doesn't do it. Audio volume control bar. This sounds like what I'm experiencing.

If you're not familiar with this product, you can ask your local auto parts shop for the material used for potable water systems on RVs. You can hear the motor but it does not pull the door in to latch. Owners may contact Toyota customer service at 1-800-331-4331. Fixed Toyota Sienna power sliding door problem. The motor has two electrical plug-ins, they should face outside. Lift it up, then use a flat head screwdriver to remove the screw coverings. Introduction: Fix Toyota Sienna (or Any Car) Power Sliding Door the Fastest and Cheapest Way.

2nd Step: Access the Track. Toyota Sienna 2004 Power Sliding Door Cable & Center Hinge Replacement. The kids have to climb over the front seat. 4th Step: Lubricate.

It is held on by 3 bolts on the back of the door and 3 bolts inside the door. According to NHTSA, "the remedy for this recall is still under development. The problem, which affects the model year 2011 to 2016 Sienna, occurs when the sliding door is "impeded" while opening automatically. The Problem: According to the National Highway Traffic Safety Administration, if the power sliding door is unable to be opened when commanded, such as if the door is frozen shut, the door may subsequently open unexpectedly, possibly while the vehicle is moving. This way, when you look for used Hiace vans for sale, you will know how to address such problem accordingly. Close the sliding doors, then move the track cover about an inch toward the rear. My simplest solution: Replace only the motor of the latch instead of the entire latch unit. What other people did: There are many resources such as YouTube of how to open the inside cover panel so I will not go into detail here. I had this problem a few times and what I found was that it was the rubber piece on the side of the door that had come part way off and was not able to close al the way even though it was an inch from closing. If you own one: Notices are expected to be mailed to owners by January 21, 2017. Toyota is still working on a fix and anticipates notifying owners of the problem in mid-January. You'll need the parts from them anyway, but they will be able to diagnose the problem so you're not just replacing parts. This will fix the problem.

That can cause the circuit to overload and open a fuse in the car, which prevents the door from latching shut properly. The 3rd picture shows what you see after you cut it open, the motor of the latch. I know this is old, but I have the answer so figured I would post so others can see. It's time-consuming and many things could go wrong. Doing so will keep clumps of mess and grease collecting in the assembly. It is a 6 inch cable. I finished it in less than one hour the first time, the 2nd time would be even quicker after knowing exactly what to do.

Finally they admitted they didn't know what was causing it. When it gets to the end of the open sequence, it can be closed without any resistance - if that makes sense. This didn't happen last year. Can it be replaced by the owner? In the rear of the Hiace van, you will find the tailgate.

Mon, 13 May 2024 02:23:20 +0000