216 Thermostat Housing Bolts

Yes, 14 ft lbs is correct. Expansion tank should be about 1/4" full. Location: The Florida State University. Just use your hands. The jiggle valve allows trapped air to exit, since the trapped air will rise to surface, so to speak. 4L auto @ 300k and climbing. Does anyone know the torque specs for the 4 thermostat housing bolts on a 1983 2F? If you are working on a 3. I've busted 4 thermostat housing studs (3 new, 1 reused) trying to torque to 14 ft-lbs. However your problem is not a matter of torque. And extremely shitty shitty production.

1. Torque specs for thermostat housing and urban development
2. Thermostat housing bolt torque
3. Torque specs for thermostat housing bubble

Torque Specs For Thermostat Housing And Urban Development

25ft/lbs seems reasonable. That frustrates me as well. Thermostat housing bolt torque setting? Posts: 502. thermostat. You continue to insist that you do thousands of parking brake repairs and yet can't be bothered to post the initial break in procedure nor are you aware of the in line adjuster and how to adjust it until I mention it.

I wonder if that can be applied to an older 216 stove bolt with cast iron thermostat housing? Coolant Inlet Pipe Nuts-------------------------------------14. 35 ft lbs is 47 Nm, if you do that the bolts will either break or strip the aluminum. Water pump bolts use thread sealer. All you are doing is pushing the new gasket between 2 pieces of metal. It's important to fill out your profile, or include details in your post. Getting some shiny new ICON ones from HF today. Joined: 02 Aug 2011, 21:52. Even worse is Al bolt in an Al thread and it not cleaned: it's pretty much cold-welded. LocTite Blue (removable) is recommended, on most fasteners, for lubrication, galvanic corrosion protection, and fastener stability purposes.

Thermostat Housing Bolt Torque

I was in a hurry, call my a hypocrite. ) Crankshaft sprocket bolt. '07 Peterbilt 386. cat c15 twin turbo acert motor no def system. Joined 17 years ago. I had to replace my thermostats because the truck was running hotter than normal under a load after blowing a coolant hose and the engine getting hot. Also is RTV acceptable on this? Many of the pages look very similar BUT do in fact have slight variations. Can anyone tell me the torque setting for the thermostat housing bolts on an LS2?

If those bolts are only 10 or 12mm then the housing is likely smaller and more delicate than I have envisioned (I have not put my dirty fingers on it yet). IMO this is a personal choice at your own risk. Start engine at idle. I'm being forced to rebuild/clean my duo-valve because it's decided to become super-sticky in the last few days. Can I ask where you got your info?

Torque Specs For Thermostat Housing Bubble

I was just wondering if it's not tight enough and needs torqued to a certain inch pound. Manage Preferences -. Fasteners of that ilk aren't usually "torqued". Also, make note of the orientation of the ''Jiggle valve" when re-installing thermostat.

Over time these things get brittle and fail. 2015 C7 of the Year Finalist. Each and every time, or when corrosion is present. Hi, Could anyone help? Currently Active Users Viewing This Thread: 1 (0 members and 1 guests). So I noticed i have a few drips on my belt and traced it to the thermostat outlet and block. Join Date: Aug 2010. I have checked my PDF service manual and no joy. I'm using blue RTV and I saw on a video that it wasn't recommended for this.

Sun, 19 May 2024 17:01:45 +0000